EasyManua.ls Logo

Polaris 2005 99 Ranger - Control and Parts Functions

Polaris 2005 99 Ranger
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
CONTROL AND PARTS FUNCTIONS
Oil and Filter Change (Cont.)
14. Reinstall drain plug.
15. Remove dipstick (2) and add 2 quarts (1.9 l) of Polaris Premium 4 synthetic oil.
Reinstall dipstick. NOTE: If sump is not drained, add about 1 3/4 quarts
initially.
16. Place gear selector in neutral and set parking brake.
17. Start engine and let it idle for one to two minutes. Stop engine and inspect for
leaks.
18. Re-check oil level on the dipstick and add oil as necessary to bring the level to
the upper mark on the dipstick.
19. Dispose of used filter and oil properly.
Fuel Filter and Oil Filter
Your Polaris RANGER is equipped with a unique in-line fuel filter.
These filters should be replaced by your dealer after every 100 hours of operation
or annually. Do not attempt to clean these filters.

Table of Contents

Related product manuals