157
Maintenance
Daytime Running Lights L amp Replacement (if equipped)
If the daytime running lights do not operate, replace the lamps. Polaris recommends that
you install replacement lamps obtained from your authorized Polaris dealer.
1. Predator 90: Locate the lamp socket below t he front cover. R otate the socket
counterclockwise about 1/4 turn and remove it from the housing.
Sportsman 90: Remove the light housing from the bumper. Separate the housing by
removing the four screws from the rear cover. Rotate the lamp s ocket counterclockwise
about 1/4 turn and remove it from the housing.
2. Without twisting, pull the lamp out of the socket.
3. Install the new lamp.
4. Reinstall the socket into the housing and rotate clockwise about 1/4 turn.
5. Start the engine to make sure the lights come on. If the lights do not operate, see your
Polaris dealer for service.
6. Reinstall any remaining components.
To Next Page
Loading...
Need help?
General
