86
Features and Controls
Kick-Start Lever
If the battery becomes too weak to start the engine, the
kick-start lever will allow you to start the engine until the
battery is serviced. Be sure the ATV is on a level surface with
the parking brake l ocked. Make sure the transmission is in
neutral (90cc m odels).
1. Fold out the kick-start lever (A) on t he lefthand side of the
ATV.
2. Make sure the stop switch is in the RUN position and turn
the key to ON.
3. Place your foot on the kick-start, and then thrust your heel
downward to crank the engine.
4. After the engine has started, fold the kick-start lever back
into place. NOTE: A 10/12mm wrench is provided in the
tool kit for removing or installing the lever. If not installed, make sure the rubber cap
is installed on t he kick-start shaft to protect the rider. On 50cc models, store the
kick-start lever under the seat (B) when it’s not installed on the ATV.
A
B
To Next Page
Loading...
Need help?
General
