6.10
TRANSMISSION
Transmission Assembly
1. Thoroughly clean the transmission case halves and shafts.
2. Inspect all seals and O-rings for damage. If transmission
was disassembled, seal and O-ring replacement is
recommended (see exploded view above).
3. If the cam shift shaft was disassembled, install the detent
gear with the step facing the O-ring.
NOTE: Both shift shafts have skip-tooth keyed
splines for assembly purposes.
4. If the bellcrank shift shaft was disassembled, install the gear
sector with the step facing the O-ring.
5. Install new O-rings on both shift shafts and lubricate prior
to installation.
Step
Replace
O-Ring
Step
Replace
O-Ring
PartShark.com
877-999-5686
To Next Page
Loading...
