8.19
FINAL DRIVE
8
16. Remove the (3) bolts retaining the input cover.
17. Remove the cover (H), armature plate (J) and cam (K).
18. Inspect the armature plate (J) and cam (K) for excessive
wear or damage. If replacement is required, replace the
armature plate and cam as an assembly.
19. Inspect the magnetic coil (L) and needle bearing (M)
located in the input cover assembly. If replacement is
required, replace the input cover as an assembly.
20. Remove the (4) screws that retain the pump neck assembly
to the main gearcase.
21. Remove the neck and input shaft assembly from the main
gearcase.
22. Inspect the pinion gear (N) for chipped, broken, or missing
teeth. Inspect the input shaft bearing (P) for signs of wear.
The bearing can be replaced separate from the input shaft.
IMPORTANT: Refer to the “Electronic Parts Catalog”
for individual part availability. Most parts are to be
replaced as an assembly or as a complete kit.
H
J
K
L
M
N
P
PartShark.com
877-999-5686
To Next Page
Loading...
