9.4
BODY / FRAME
FRONT BUMPER
Removal / Installation
1. Remove the (2) push rivets from each side of the bumper.
2. Remove the (4) bolts retaining the upper front bumper to
the frame.
3. Remove the bulbs from the head lights by turning the bulbs
90° counterclockwise and remove the upper front bumper
from the vehicle.
4. If removing the lower front bumper, remove the (2) bolts
from each side retaining the bumper to the frame.
5. Reverse this procedure to reinstall the front bumper.
MUD GUARDS
Removal / Installation
1. Locate the mud guards in the front wheel well area.
2. Remove the (4) push rivets from each mud guard and
remove from them from the wheel well.
3. Reverse this procedure to reinstall the mud guards.
FOOTWELLS
Removal / Installation
1. Remove the seat and upper side panel (see “SEAT AND
SIDE PANELS”).
2. Remove the push rivets and screws that retain the footwell.
3. Repeat this procedure to remove the other footwell.
4. Reverse this procedure to reinstall the footwells.
NOTE: Be sure to properly align the cab ends into
the footwells upon reassembly.
PartShark.com
877-999-5686
To Next Page
Loading...
