9.6
BODY / FRAME
REAR RACK
Removal / Installation
1. Remove the (8) Torx-headed fasteners as shown below.
2. Remove the rear rack and rack support from the rear cab.
3. Reverse this procedure to reinstall.
REAR BUMPER COVERS
Removal / Installation
1. Open the rear storage compartment and remove the (4)
bolts retaining the rear bumper covers.
2. Remove the (4) screws retaining the rear cab to the frame
(see “REAR CAB”).
3. Lift up on the rear cab and remove the bumper covers by
sliding them off the rear bumper.
4. Reverse this procedure to reinstall the covers.
REAR CAB
Removal / Installation
1. Remove the (10) push rivets and (4) Torx-headed screws
retaining the rear cab assembly.
2. Remove the tail light bulbs from the tail lamps, disconnect
the tail light harnesses from the rear cab, and remove the
rear cab as an assembly.
3. Reverse this procedure to reinstall. Be sure to lock the tail
light bulbs in place by turning them 90° clockwise.
PartShark.com
877-999-5686
To Next Page
Loading...
