3.24
ELECTRONIC FUEL INJECTION
Primary Test
Secondary Test
Ignition Coil and HT Lead Replacement
NOTE: The plug caps or coil ends are not
removable. The high tension lead (coil wire) must be
replaced as an assembly.
1. Remove the seat and upper right-hand side panel to access
the ignition coil (see Chapter 9 “Seat and Side Panels”).
2. Disconnect the shift linkage and remove the high tension
lead caps from the spark plugs.
3. Remove the high tension leads from the airbox.
4. Disconnect the harness from the ignition coil.
5. Using a T20 driver, remove the screw retaining the ignition
coil to the airbox.
6. Remove the coil assembly and disconnect the high tension
leads by pulling on the coil side end caps.
7. Install the new high tension leads.
NOTE: Be sure to install the PTO (long) wire on the
coil terminal nearest the airbox.
8. Install the coil assembly and securely tighten the mounting
screw.
9. Upon assembly, make sure the high tension leads are
retained by the airbox.
10. Reinstall the shift linkage, upper right-hand side panel and
the seat.
Measure Between
Connector Pins 1 & 2, 2 & 3
0.4 Ω
Measure Between End Caps
MAG (Short) Wire: 1390 Ω ± 2 %
PTO (Long) Wire: 1545 Ω ± 2 %
PartShark.com
877-999-5686
To Next Page
Loading...
