49
FEATURES AND CONTROLS
Digital/Analog Gauge
Rider Information Center
Information Display Mode
Clock Resetting
Tip: The clock must be reset any time the batteries have been
disconnected or fully discharged.
1. Turn the key to the ON position. Use the MODE
button to toggle to the clock display.
2. Press and hold the MODE button until the hour
segment flashes. Release the button.
3. With the segment flashing, tap the MODE button to
advance to the desired setting.
4. Press and hold the MODE button until the next segment flashes. Release the button.
5. Repeat steps 3-4 twice to set the 10-minute and 1-minute segments. After completing the
1-minute segment, step 4 will save the new settings and exit the clock mode.
6. Turn the key to the OFF position.
To Next Page
Loading...
Need help?
General
