137
TROUBLESHOOTING
M-10 Suspension Troubleshooting
Problem Solution
Rear suspension bot-
toms too easily
• Increase FRA position (see setup decal under hood for ini-
tial position
• Increase X-over tube length (see setup decal under hood)
• Increase rear track shock coil spring preload
• Increase front track shock coil spring preload
• Change to optional stiff rear track shock compression
spring (see your dealer)
• Revalve rear track shock compression damping (see your
dealer)
• Check track tension
Rides too stiff in rear • Decrease FRA position (see setup decal under hood)
• Decrease rear track shock coil spring preload
• Change to optional soft rear track shock compression
spring (see your dealer)
• Revalve rear track shock compression damping (see your
dealer)
• Check track tension
Machine darts from
side to side
• Make sure skis are aligned properly
• Make sure spindles and all steering components turn
freely
• Make sure skags are straight on skis
• Increase IFS preload
• Ensure use of Accu-Trak dual skags
Front end pushes • Check for worn skags
• Check for binding suspension shafts and grease all pivot
points
• Increase front IFS preload
• Shorten front limiter strap
Steering is heavy • Check ski alignment
• Check skags and skis for damage
• Decrease IFS preload
• Make sure spindles and all steering components turn
freely
To Next Page
Loading...
Need help?
General
