85
MAINTENANCE
Periodic Maintenance Interval Table
The following chart is a guide based on average riding conditions. You
may need to increase frequency based on riding conditions. When
inspection reveals the need for replacement parts, always use genuine
Polaris parts, available from your Polaris dealer.
I - Inspect (clean, adjust, tighten, lubricate, replace if necessary)
C - Clean R - Replace L - Lubricate
Item See
Page
Frequency
150 mi.
(240 km)
500 mi.
(800 km)
1000 mi.
(1600 km)
2000 mi.
(3200 km)
Pre-
Season
CLUTCH
Clutch Alignment Offset
(without belt)
110 II I
Drive Belt Condition 111 II II
Clutches (disassemble) 109 CC C
Belt Tension -- II II
Clutch Sheaves 109 II II
ENGINE/COOLING
Engine Mounts -- II II
Recoil Rope -- II II
Engine Mounting Plate -- II I
Engine Torque Stop 115 II II
Cylinder Head Bolts -- II I
Cylinder Base Nuts -- II I I
Ignition Timing BTDC -- II I
VES System -- CC C I
Coolant Level 100 IIRI
Water Pump Drive Belt 111 II I
Coolant Hose -- II II
Heat Exchangers -- II I I I
Coolant Circulation -- II I
Coolant Leaks -- II II
Spark Plug Condition 93 II IRI
Exhaust Pipe 99 II
Exhaust Retaining
Springs
99 II II
To Next Page
Loading...
Need help?
General
