EasyManua.ls Logo

Polaris 9919412 - Page 109

Polaris 9919412
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
106
MAINTENANCE AND LUBRICATION
Cleaning and Storage
Storage Tips
Fog the Engine
1. Re move the spark plug and add 2-3 table spoons of Premium 4
Synthetic 0W40 engine oil. To access the plug hole, use a section of
clear 1/4ā€ hose and a small plastic squeeze bottle f illed with the
pre -me asure d amount of oil.
NOTE: Do this carefully! If you miss the plug hole, oil will drain from
the spark plug cavity into the hole at the front of the cylinder
head, and appear to be an oil leak.
2. Re install the spark plug. Torque to 18 ft. lbs. (24 Nm).
3. Apply diele ctr ic grea se to the inside of the spar k plug ca p and install
the ca p onto the plug.
4. Turn the engine over seve ra l times. Oil will be force d in and around
the piston rings a nd ring lands, coa ting the cy linder with a prote ctive
film of fre sh oil.
Alternative to Using Fogging Oil
If you choose not to use P olaris F ogging Oil, perform the following
procedure.
1. Treat the fuel system with Polaris Carbon Clean, following the
instructions on the can. Run the engine for several minutes so the
Carbon Clean reaches the carburetor. T urn the engine off.
2. Support t he front end of the machine so t he engine is level or tilted
slightly rearward.
3. Remove the spark plug. Rotate the piston to BDC and pour
approximately two ounces of recommended oil into the cylinder.
4. Re install the spark plug and torque to 18 ft. lbs. (24 Nm).
5. Apply diele ctr ic grea se to the inside of the spar k plug ca p and install
the ca p onto the plug.
6. Turn the engine over several times to ensure coverage of piston
rings, cylinder walls and crankshaft bearings.
7. If Polaris fuel system additive is not used, fuel tank, fuel lines, and
carburetor should be completely drained of gasoline. To eliminate
any fuel remaining in the carburetor, run the engine until it stops.
Inspect and Lubricate
Inspect all cables and lubricate. Follow lubrication guidelines in the
Maintenance Section of the service or owner’s manual to completely
grease and lubricate the entire vehicle with Polaris P remium All
Season Grease.

Table of Contents

Related product manuals