104
ADJUSTMENTS
Handlebars
The handlebars can be adjusted for rider preference.
1. Loosen the four handlebar bolts.
2. Adjust the handlebar to the
desired height.
NOTE: Be sure the handlebars do not
contact the gas tank or any
other part of the machine
when turned fully to the left or
right.
3. Torque the front two bolts to
14-17 N-m, then torque the rear
two bolts. A gap of up to 3 mm
will remain at the rear bolts.
WARNING
Improper adjustment of the handlebars or incorrect torquing of the adjuster
block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control. Follow the adjustment procedures
exactly, or see your Polaris dealer for service.
Handlebar
Bolts
To Next Page
Loading...
