96
MAINTENANCE
Engine Oil
Oil Change
18. Remove the oil filter cap, then remove the oil filter. Inspect the o-
ring and replace it if it's worn or damaged.
19. Install a new filter, then reinstall the cap. Tighten the cap to 18.5 ft.
lbs. (25 Nm).
20. Remove the jumper from the starter motor wiring harness. Recon-
nect the solenoid and the originally-installed harness. Reinstall the
20A EFI Fuse.
21. Remove the dipstick from the oil tank. Add 2 quarts (1.9 liters) of
the recommended oil. Reinstall the dipstick.
22. Start the engine and allow it to idle for 3-5 minutes. Make sure the
engine coolant temperature is between 145 and 160 degrees F. (63-
71 degrees C).
23. Stop the engine.
24. Remove the dipstick from the oil tank. Clean the dipstick with a
clean shop towel and reinstall it, screwing it in completely.
25. Remove the dipstick and view the oil level.
To Next Page
Loading...
