FINAL DRIVE
7.34
N
11. Remove the retaining ring (O) and shim (P) from
the rear output thru shaft.
O
P
12. Carefully pull the output thru shaft (Q) through the
gearcase.
Q
13. Remove the retaining ring (O), shim (P), and input
gear (R) from the output thru shaft (Q). Inspect
the input gear for abnormal wear, broken, or
chipped teeth.
Q
R
P
O
14. Inspect the two flange bearings (S) inside the
gearcase. Inspect the pinion shaft bushing (T) for
wear that is inside the gearcase.
S
T
S
15. Replace all O--ring, seals, and worn components.
Replace the seals as shown in the photo.
To Next Page
Loading...
