37
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Accessing Blink Codes
The EFI diagnostic mode is for informational purposes only. Please see
your Polaris dealer for all major repairs.
See page 38 for Blink Codes and Failure Descriptions. Use the follow-
ing procedure to access blink codes (failure codes) from the EFI mod-
ule.
1. Apply the brakes.
2. Place the transmission in PARK.
3. Stop the engine.
4. Turn the key switch to the ON position.
5. Turn the key switch off and on three times in less than five seconds,
then leave the switch on. Any blink code numbers stored in the EFI
module will display, one at a time, on the screen. The number “61”
and the word “END” displays after all codes have been transmitted.
To Next Page
Loading...
