Polaris RANGER RZR 170 - Rear Brake Caliper Installation

6.24
BRAKES
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
NOTE: The parking brake cable can be
disconnected by loosening jam nut (C) and backing
out adjuster bolt (D) a few turns.
7. Remove two caliper mounting bolts and caliper
assembly.
8. Place a container below caliper to catch brake fluid
and remove brake line from caliper. Immediately
cover and seal end of brake line to prevent
contamination.
Rear Brake Caliper Installation
1. Install caliper and torque mounting bolts to
specification.
2. Bleed rear brake system. See “BRAKE BLEEDING /
FLUID CHANGE” on page 6.7.
3. Attach parking brake cable to lever arm with one
washer (A) on each ends of spring. If lever arm plate
was removed, install plate and torque bolts (B) to 12
ft-lbs. (16 Nm).
C
D
= T
Rear Caliper Mount Bolt:
18 ft-lbs (24.5 Nm)
= T
Brake Line Banjo Bolt:
14.5 ft-lbs (19.6 Nm)
18 ft-lb. (24.5 Nm)
14.5 ft-lb. (19.6 Nm)
A
B