Polaris RANGER RZR 170 - Transmission Main Shaft Assembly View

7.18
CVT / TRANSMISSION
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
Transmission Main Shaft Assembly View
1. Refer to Fig. 3 for assembly view. Replace all
retaining rings if removed.
2. Remove flat washer (A), circlip (B), shaft collar (C),
washers (D) (one washer on each side of gear E),
sliding dog gear (F), snap ring retainer (G), splined
washer (H), gear with needle bearing (I), and thrust
washer (J).
3. Inspect forward / reverse dog gear. Closely inspect
outer corners of dogs for rounding or damage (K).
4. Inspect edges of slots (L) in forward and reverse gears
for severe rounding that would reduce contact area of
sliding gear dog. Compare leading and trailing edges
of slots to determine level of wear. Inspect needle
bearing (M).
A
C
E
B
D
D
G
F
J
I
H
Fig. 3
K
L
M