3.42
ENGINE
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
5. Disconnect the wire securing the cam chain and loop
the cam chain over the camshaft sprocket while
verifying the cam is inserted with the alignment marks
parallel to the gasket surface.
6. Verify all cam timing marks to verify proper cam timing,
and install the rocker arm assembly (see Method 1
illustration). Torque the cylinder stud nuts to
specification.
NOTE: Do not rotate engine until rocker assembly
and tensioner are installed.
7. Install the tensioner. Torque fasteners to specification.
8. After tensioner installation, rotate engine at least two
revolutions and re-check marks/timing.
To Next Page
Loading...
