Polaris RANGER XP 1000 2018 - Page 161

3
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
3.69
17.Install dowel pins
a
into oil pump mounting holes.
18.Install the three bolts
f
that retain oil pump
d
to the
crankcase. Torque mounting bolts to specification.
TORQUE
Oil Pump Mounting Bolts:
7 ft-lbs (10 Nm)
19.Reinstall oil pump pick-up
s
. Torque mounting
screws to specification.
TORQUE
Oil Pump Pick-Up Retaining Screw:
7 ft-lbs (10 Nm)
20.Clean the gasket sealing surfaces on oil sump cover
and crankcase to remove old gasket material and any
oil.
NOTE
Gasket surfaces must be DRY and oil free. Use care
upon assembly to keep oil away.
21.Apply a thin, continuous film of Crankcase Sealant
(PN 2871557) to sump cover mating surface
g
as
shown. Do not allow sealant to dry before assembly.
NOTE
Dipstick must be removed before oil pan is assembled
to the engine. Failure to do this will damage the
dipstick.
22.Install the oil sump cover
h
onto the crankcase.
23.Install the thirteen M6
j
and three M8 bolts that
retain the oil sump cover
k
to the crankcase.
ENGINE / COOLING / EXHAUST