3.70
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
24.Torque the oil sump cover bolts in sequence to
specification. Repeat the sequence to verify final
torque.
TORQUE
Oil Sump Cover Bolts:
M8 Bolts: 26 ft-lbs (35 Nm)
M6 Bolts: 9 ft-lbs (12 Nm)
25.Install the crankcase drain plug if previously removed.
Torque drain plug to specification.
TORQUE
Crankcase Drain Plug:
12 ft-lbs (16 Nm)
26.Install the oil cooler
l
. Use new O-rings
1 (
upon
installation.
27. Torque fasteners to specification in sequence shown.
TORQUE
Oil Cooler Retaining Bolts:
7 lb-ft (10 Nm)
28.Proceed to Flywheel Installation, page 3.72 and then
Cylinder Head Installation, page 3.74.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
