3
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
3.71
STARTER ONE-WAY CLUTCH ASSEMBLY
1. Install one-way clutch in clutch hub with flange of
clutch
q
engaged in recess.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Place one-way clutch on flywheel and install the three
screws. Torque screws to specification.
TORQUE
One-Way Clutch Retaining Screws:
9 ft-lbs (12 Nm)
4. Reassemble starter one-way clutch and gear using
the following illustration.
q
Torque Limit Gear Pin
t
Flywheel
w
Starter Gear
y
One-Way Clutch Retaining
Screws 9 ft-lbs (12 Nm)
e
One Way Clutch Asm.
u
Torque Limit Gear Asm.
r
Flywheel Retaining Bolt
Step 1: 133 ft-lbs (180
Nm)
Step 2: Back out bolt 180°
& retorque to spec.
5. If starter gear was replaced, inspect the torque limit
gear.
6. After assembly, be sure the starter gear rotates in the
clockwise direction only.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
