4.10
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
FUEL LINE REMOVAL / INSTALLATION
1. Place a shop towel around the fuel line to catch any
dripping fuel.
2. To remove either end of the fuel line, pull open tabs
q
and
w
while moving the connector out to release
the line.
3. Disconnect the fuel line connector
e
securing the
fuel line to the clutch.
4. Pull the fuel line outward to remove.
5. To reinstall the line, verify the connections are clean
and free of debris.
6. Place the fuel line back over the fitting and slide the
connector locking mechanism back into place. Verify
the connector tabs snap back into place by pulling out
lightly on connector.
7. Be sure fuel line is routed and retained properly. See
Fuel Line Routing, page 4.9.
FUEL SYSTEM
To Next Page
Loading...
