Polaris RANGER XP 1000 2018 - PVT Inner Cover Assembly

5
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
5.13
10.If necessary, remove the outer slip-fit post and install
the Drive Clutch Puller (PN PU-52422) to remove the
Stationary Sheave.
WARNING
Engine and Transmission must be supported before
proceeding.
11. Remove Transmission Support fasteners
u
.
12.Remove three bolts
i
that retain the inner clutch
cover to the engine. Remove bolts
o
and
a
that
secure the clutch cover to the transmission.
NOTE
The transmission will need to be lowered until sufficient
clearance is gained to remove the lowest mounting bolt
o
.
13.Remove the inner clutch cover from the vehicle.
PVT INNER COVER ASSEMBLY
1. Inspect the inner clutch cover. Replace if cracked or
damaged.
2. Inspect the seal
q
on the transmission input shaft.
Replace if damaged.
3. Inspect inner clutch cover seal (engine side). Replace
if cracked, torn or damaged.
PVT SYSTEM