Polaris RANGER XP 1000 2018 - Page 296

5.16
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
16.Install shims
s
(0–8) as required, washer
d
, and the
Driven Clutch Bolt
f
.
17.Torque the Driven Clutch Bolt
f
using a 6 inch
extension
g
wedged between the movable sheave
and the upper A-arm.
TORQUE
Driven Clutch Retaining Bolt:
43 lb-ft (58 Nm)
18.Install the Drive Clutch Stationary Sheave. Ensure
the Sheave is fully seated
19.Install the Drive Clutch assembly and Drive Clutch
bolt
h
.
IMPORTANT
Ensure proper orientation of washers. Orientation
should be as follows: Clutch Spider, Yellow Washer,
Silver Belleville Washer with dome side facing outwards
towards Outer Post, and Outer Post.
TORQUE
Drive Clutch Retaining Bolt:
96 lb-ft (130 Nm)
20.Install the PVT inlet duct hose. Torque the hose clamp
to specification.
PVT SYSTEM