6.14
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
10.Install zip ties retaining fuel lines and harnesses to
intake manifold.
11. Connect harness going to TMAP sensors, CPS,
coolant temp sensor, Trans switch, speed sensor,
injectors, ETC.
12.Connect the fuel supply at the fuel rail.
13.Install shift cable assembly. Tighten the lower jam nut
w
until the line meets with the upper shift cable jam
nut
q
.
14.Connect the transmission shift cable to the bellcrank.
Install the clip and sliding the washer.
15.Install two bolts securing the Rear Prop Shaft to the
transmission. Torque to specification.
TORQUE
Rear Prop Shaft (to transmission) Fasteners:
22 ft-lbs (30 Nm)
16.Install cargo box. Torque fasteners to specification.
TORQUE
Cargo Box Bracket Fasteners:
5 ft-lbs (7 Nm)
17.Check the transmission fluid level. See Transmission
Fluid Level Inspection, page 2.48
18.Connect the battery. Torque fasteners to
specification.
TORQUE
Battery Fasteners:
40 in-lbs (5 Nm)
TRANSMISSION
To Next Page
Loading...
