7.12
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
9. Lift the Electrical Harness
u
out of the center of the
hard plastic intake and slide to the side.
10.Loosen four Worm Clamps
i
retaining the hard
intake line from the rubber lines.
11. Slide the plastic intake rearward & then frontward to
angle out driverside of vehicle.
12.Remove two carrier bolts
o
.
13.Remove front propshaft pin.
14.Slide prop shaft forward enough to allow clearance to
lift back of prop shaft up and out the opening in the
footwell.
FINAL DRIVE
To Next Page
Loading...
