Polaris RANGER XP 1000 2018 - Page 387

7
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
7.35
6. Install the LH output hub
s
into the gearcase
housing. The output hub should spin freely.
7. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
8. Install the rollers and roll cage into the ring gear.
Insert the rollers as the roll cage is installed.
9. Install the pins
a
, roll cage
o
, and ring gear
assembly
i
into the gearcase housing.
10.Align the spring retainer dowel pin with the ring gear
dowel pin and install the retainer
y
on top of the
torsion spring.
11. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
12.Install the armature plates
t
. Be sure the armature
plate tabs are fully engaged into the roll cage
assembly.
NOTE
Verify armature plate tabs are in the slots on the roll
cage and are resting in the ring gear grooves.
FINAL DRIVE