7. Using an appropriate oil filter wrench, rotate the oil filter cap
w
counter-
clockwise to remove the cap and filter unit.
8. Remove the filter from the cap.
9. Using a clean, dry cloth, clean the filter sealing surface on the crankcase.
10. Lubricate the gasket area on the new oil filter with a thin film of clean engine
oil.
11. Install the new filter onto the oil filter cap.
12. Lubricate the o-ring on the oil filter cap with a thin film of clean engine oil.
13. Use the oil filter wrench to reinstall the cap/filter unit. Tighten to specification.
TORQUE
16 ft-lbs (22 Nm)
14. Remove the oil fill cap
q
. Add the recommended oil. Do not overfill.
FLUID CAPACITY
4.5 qts (4.25 liters)
15. Reinstall the oil fill cap.
16. Shift to neutral.
17. Start the engine and allow it to idle for 1-2 minutes. Stop the engine.
18. Check for leaks around the drain plug and oil filter.
72
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
