3. Inspect the rotor to ensure tightness to hub.
4. Check the brake pads for wear, damage and looseness.
5. Inspect brake discs for nicks, scratches, cracks or other damage. Clean any
grease using an approved brake cleaner or alcohol.
WARNING
Do not apply WD-40 or any petroleum product to brake discs. These types of
products are flammable and may also reduce the friction between the brake
pad and caliper.
6. Inspect the brake disc spline and pad wear surface for excessive wear.
Change pads when worn to 3/50'' (1.5 mm).
7. Inspect the thickness of each brake disc at four or more locations around the
disc. If any disc is worn to the minimum thickness at the thinnest point, or if a
disc is damaged, see your dealer for replacement.
8. The SLR model comes with a 2–piece rotor. Check that the rotor is tightened
adequately to the hub.
3/50'' (1.5 mm)
Minimum Thickness
Front: 19 mm / Rear: 19 mm
91
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
