CLUTCH
6.45
BUSHING REPLACEMENT, EBS DRIVEN, CONT.
EBS Driven - Backside (Outer) Bushing Removal
1. Install main puller adapter (Item 8) onto puller.
2. Install adapter reducer (Item 9).
3. Using a hand held propane torch, apply heat around
outside of bushing until tiny smoke tailings appear.
CAUTION: Clutch components will be hot! In order to
avoid serious burns, wear some type of insulated gloves
for the rest of the removal process.
4. Flip sheave over onto puller .
5. Install bushing tool (Item 2).
6. Installlefthandnut(C)andspacerontopullerrodand
tighten by hand. Turnpuller barrelfor further tension
if needed.
7. T urnclutchsheave counterclockwiseuntil bushingis
removed and sheave comes free.
8. Removenut (C)(left handthread) frompullerrodand
set aside.
9. Remove adapters from puller.
10. Remove bushing and removal tool from adapters.
Discard bushing.
EBS Driven - Backside (Outer) Bushing Installation
1. Install puller adapter (Item 10) onto puller.
2. Install adapter (Item 9) onto puller.
3. Apply Loctitet 609 evenly to bushing bore inside
moveable sheave.
4. Install sheave face down on puller.
5. Install new bushing on installation tool (Item 2) and
install assembly into sheave.
6. Install left hand thread nut (C) onto puller rod and
hand tighten against installation tool.
7. T urn clutch sheave counterclockwise, making sure
bushing is drawn straight into bore. Continue until
bushing is seated.
8. Removenut (C)(left handthread) frompullerrodand
set aside.
9. Remove installation tool and clutch sheave from
puller.
Heat Bushing Surface Prior To Installation/
Removal OF Bushings
Main Adapter
(8)
Nut (C)
Adapter
Reducer (9)
Bushing
Tool (2)
Bushing
Tool (2)
EBS Driven Clutch Outer Bushing Removal
Nut (C)
Bushing
Tool (2)
Bushing
EBS Driven Clutch Outer
Bushing Installation
Adapter
(9)
Puller Adapter
(10)
To Next Page
Loading...
