FINAL DRIVE
7.30
REAR HUB DISASSEMBLY
1. Remove outer snap ring.
2. From the back side, tap on the outer bearing race
with a drift punch in the reliefs as shown.
NOTE: Drive bearing out evenly by tapping on outer
raceonly. Once bearingis at bottom of casting,support
casting on outer edges so bearing can be removed.
3. Inspect bearing.
NOTE: Due to extremely close tolerances and mini-
malwear,thebearingsmustbeinspectedvisually,and
by feel. While rotating bearings by hand, inspect for
roughspots, discoloration, orcorrosion. Thebearings
should turn smoothly and quietly, with no detectable
up anddownmovement and minimal movement side-
ways between inner and outer race.
4. Inspect bearing housing for scratches, wear or
damage. Replace housing if damaged.
To Next Page
Loading...
