TRANSMISSION
8.30
TRANSMISSION ASSEMBLY, CONT.
30. Pre-lubricate all bearings with Polaris Premium
SyntheticGearCaseLubricantbeforeinstallingcover.
31. Place the bellcranks in neutral so shift fork shafts will
engage into the spring loaded detents of case cover.
32. Be sure sealing surfaces of cover and
transmissioncaseareclean. Apply3Bondt 1215
tosurfaceofcaseandinstallcoverbolts. Torqueto
specification in three steps, following a cross
pattern. Start with the center (2) bolts.
33. Install seal installation tool in drive gear as shown.
Lubricatenew sealwithgreaseandslideontotool.
Drive seal into place using large end of slide
hammer. Repeat procedure for other side.
Torque 5/16 bolts (2)
17 - 20 ft. lbs. (23.5 - 27.7 Nm)
Torque 1/4 bolts
8 - 10 ft. lbs. (11 - 11.4 Nm)
Seal Installation Tool
(Slide Hammer) PN 2871698
(Seal Guide) PN 2871699
Start with two
center bolts
To Next Page
Loading...
