BRAKES
9.23
REAR BRAKE PAD REMOVAL
1. Removecalipermounting bolts andliftcaliperoff of
disc.
NOTE: When removing caliper, be careful not to dam-
agebrakeline. Supportcalipersoasnottokinkorbend
brake line.
2. Push caliper piston into caliper bore slowly with
pads installed.
NOTE: Brakefluidwillbeforcedthroughcompensating
port into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.
3. Remove brake pad retaining pin, and pad spacer .
NOTE: This is a spring pin, do not spread apart farther than
necessary to remove it.
4. Clean pad retainer pins with a wire brush.
5. Clean the caliper w/ brake cleaner or alcohol.
6. Measure the thickness of the pad material.
Replace pads if worn beyond the service limit.
Measure
Thickness
Rear Brake Pad Thickness
New .275″ (7.0 mm)
Service Limit .150″ (3.81 mm)
To Next Page
Loading...
