MAINTENANCE
2.15
THROTTLE CABLE / ELECTRONIC THROTTLE
CONTROL (ETC SWITCH)
ADJUSTMENT
1. Slide boot off throttle cable adjuster and jam nut.
2. Place shift selector in neutral and set parking brake.
3. Start engine and set idle to specified RPM, thenshut
off engine.
NOTE: Be sure the engine is at operating temperature.
See Idle Speed Adjustment.
4. Loosen lock nut on in-line cable adjuster (Ill. 1).
5. T urn adjuster until 1/16″ to 1/8″ freeplay is achieved
at thumb lever. (Ill. 2). While making adjustment,
quickly actuate the thumb lever several times.
6. T ightenlocknutsecurelyandslidebootcompletelyin
place to ensure a water-tight seal.
7. T urn handlebars from left to right through the entire
turning range. If idle speed increases, check for
proper cable routing. If cable is routed properly and
in good condition, repeat adjustment procedure.
Boot
Adjuster
Sleeve
Lock-
nut
Boot
Ill. 1
1/16″ -1/8″
Freeplay
Direction
of travel
Ill. 2
To Next Page
Loading...
