111
MAINTENANCE AND LUBRICATION
Lights - Adjustment - Replacement
Headlight Lamp Replacement
.
1. Using a small flat blade screwdriver, push in on the lock tab
through the two small openings at the front of the headlight pod.
2. Lift the pod lightly while depressing the tabs.
3. R emove the screw in the back of the headlight pod
4. Lift pod cover up. Disconnect speedometer harnesses from
speedometer. Unplug indicator light harness and remove pod
cover.
5. Unplug headlamp from wiring harness.
6. Remove boot and locking collar from back of lamp housing.
7. Grasp base of l amp and lift it out.
8. R everse previous steps t o replace lamp and reassemble pod. Make
sure tab on lamp locates properly in housing.
WARNING
Due to the nature of these vehicles and where they are ridden,
headlight and taillight lenses become dirty. Frequent washing is
necessary to maintain lighting quality. Poor lighting while riding
can result in severe injury or death
Snap pins
into tabs
Position
knob in
slot and
secure in
locking
tabs
Slip O-Ring
over pin
Adjustment
Knob Stop
Route plug
over
handlebar
To Next Page
Loading...
