FINAL DRIVE
7.26
7. Inspect the ring gear for abnormal wear, broken,
or chipped teeth. Spin the bearing to check the
ball bearings for smoothness. Replace the
bearing if needed.
REAR GEARCASE
REASSEMBL
Y
1. Inspect the pinion shaft bushing for wear.
2. Replace all O--rings, seals, and worn
components.
3. Install the pinion shaft into the gearcase housing.
Install the pinion shaft cover and torque the cover
bolts to 25 ft. lbs. (34 Nm).
Enfocus Software - Customer Support
To Next Page
Loading...
