FINAL DRIVE
7.27
Pinion Shaft Cover Bolt Torque:
25 ft. lbs. (34 Nm)
4. Install the original shim(s), thrust button, and
thrust button shims into the gearcase cover.
5. Apply Crankcase Sealant (PN 2871557)to
surface of case and install cover bolts. Install the
gearcase cover onto the gearcase housing.
Torque the cover bolts to 25 ft. lbs. in a criss cross
pattern.
Gearcase Cover Bolt Torque:
25 ft. lbs. (34 Nm)
6. Install the drain plugs. Replace the drain plug
washers to ensure proper sealing after filling.
Enfocus Software - Customer Support
To Next Page
Loading...
