ENGINE
3.42
NOTE: Be sure to place the tapered end of the valve
(dowel) in first. If the valve is installed incorrectly, oil
pressure and oil priming problems will occur.
DISASSEMBLY OF WATER/OIL PUMP SHAFT
WARNING
Wear appropriate safety gear
during this procedure. Heat resistant gloves,
clothing and eyewear are required.
30. Heat oil/water pump drive housing (T). Remove
from shaft using a soft hammer.
Heat Housing
T
31. Remove the gear shaft from the water/oil pump
housing.
32. Press gear from shaft.
Press out gear
33. Press bearing from shaft. Replace the old
bearing with a new bearing during assembly.
Bearing
WATER/OIL PUMP REASSEMBLY
34. Press shaft into new gear. NOTE: Boss side of
gear faces out.
Enfocus Software - Customer Support
To Next Page
Loading...
