32
FEATURES AND CONTROLS
Engine Electrical Switches
WARNING
Activating the override switch while the throttle is open can cause
loss of control, resulting in severe injury or death. Do not activate
the override switch while the throttle is open.
Mode/Reverse Override Switch (1) - This vehicle is equipped with a
reverse speed limiter system. To gain additional power while backing,
depress the override switch.
NOTE: The override switch also allows activation of All Wheel Drive
in reverse, if the AWD switch is on. This switch is also used
to toggle through the different modes of the rider information
center. See page 40.
Engine Stop Switch (2) - The engine will
not start or run when the switch i s in the
OFF position. Its purpose is to provide the
operator with a quick means of engine
shutdown in case of an emergency.
NOTE: The cooling fan motor does not shut off when the stop switch
is used to stop the engine. Turn off the main ignition switch
to turn off the cooling fan motor.
Main Switch (3) - To start the engine, slide the stop switch to t he
center RUN position and turn the main key switch clockwise past the
ON position. Release the key when the engine starts.
NOTE: Both the main switch and the emergency engine stop switch
will shut off all electrical power to the vehicle, including lights.
To stop the engine, slide the stop switch either right or left to
the OFF position.
Worklight Switch (4) - The worklight switch controls a light located
at the rear of the vehicle. Use the rear light when additional light is
needed for loading and unloading the vehicle. Turn the rear worklight
off when driving the ATV.
1
3
2
4
RUN
OFFOFF
2
To Next Page
Loading...
