FINAL DRIVE
7.12
10. Inspect the armature plate (F) for a consistent
wear pattern. Uneven wear of the armature plate
(F) indicates a warped plate, which may cause
intermittent operation.
11. Remove the thrust bearing (G) from the output
hub (D). Inspect the thrust bearing (G) and the
dowel (H).
D
G
H
12. Remove the other output hub from the main
gearcase.
13. Remove the O--ring and seal from the output
cover.
14. Remove the input cover, bearing, and the pinion
gear. Inspect the pinion gear for chipped, broken,
or missing teeth. Inspect the output shaft
bushing. Replace as needed. Clean the inside
surfaces of both gearcase halves.
To Next Page
Loading...
