3.60
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
27. Reinstall the camshaft gear; so the timing marks are
properly aligned. Install the washer and bolt. Torque
to specification.
Be sure all of the timing marks are properly
aligned.
28. Before installing the gear/stator housing, replace the
seals in the cover. Install a new water pump seal (N)
into the gear/stator housing (O). Use the Water
Pump Mechanical Seal Installer (PA-44995) to
properly install the seal to the correct depth in the
cover.
NOTE: Due to seal design and construction,
seals MUST be installed DRY (no lubricant)
during assembly. Use of lubricants (oil, soapy
water, etc.) will not allow the seal to wear-in and
seal properly. Do not touch seal surface or allow
seal surface to come in contact with
contaminates during installation. Thoroughly
clean parts, tools and hands before installation.
To remove the water pump seal, the gear/stator
housing must be removed. The water pump seal
cannot be removed or installed with the gear/
stator housing attached to the engine. Shaft
damage will occur.
ENGINE
To Next Page
Loading...
