4.16
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
WARNING
Check the fuel rail for any possible fuel seepage after
performing any tests or procedures. Fuel is extremely
flammable and may cause severe burns, injury, or
death. Do not use any device that produces a flame or
electrical devices that may spark around fuel or fuel
vapors.
8. Remove the air box cover and remove the two gas
tank mounting bolts at the rear of the gas tank.
9. Carefully pull the fuel tank out of the frame. Keep the
fuel tank horizontal during removal, this will keep the
fuel in the tank from spilling out the top inlet.
FUEL TANK INSTALLATION
10. Reinstall the pump/tank assembly.
11. Reconnect the sender wiring harness and route the
harness properly. Install the fuel line and secure the
fuel line clamps.
12. Reinstall the two fuel tank mounting bolts at back of
tank. Tighten sufficiently.
13. Reinstall the PVT intake duct, gas tank vent line,
front cab assembly, and side panels.
NOTE: Properly route the gas tank vent line, use
tape to secure the vent line in place.
14. Reconnect the negative battery cable. Test the
sender for proper operation.
FUEL SYSTEM - GENERAL
To Next Page
Loading...
