7.42
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
8. Remove the york shaft seal using a seal remover or
suitable tool to pierce the seal and pry it out.
9. Using a shop press, press the york shaft at the input
end to remove shaft assembly from the housing .
10. Spin the bearing and check for smoothness. Remove
the snap ring and pull the bearing if replacement is
required.
IMPORTANT: Replace bearings upon removal,
as removal can cause permanent internal
damage.
11. Remove the pinion gear bearing using a bearing
splitter and puller.
IMPORTANT: Replace bearings upon removal,
as removal can cause permanent internal
damage.
FINAL DRIVE
To Next Page
Loading...
