3.50
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
36. Press gear onto shaft while supporting the housing.
37. Remove thrust plate (U).
38. Remove PTO end engine mount Remove crankcase
bolts. Tap on the reinforced areas on the cases using
soft hammer. Carefully separate the two crankcase
halves.
IMPORTANT: Only remove the oil baffle if the
baffle is damaged. When removing the oil baffle
bolts, use a heat gun to heat the bolts and loosen
the Loctite. This will prevent any possible
damage to the bolts or to the crankcase casting.
39. Remove and clean oil pick up (V) and oil baffle
weldment (W).
ENGINE
To Next Page
Loading...
