3.68
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
3. Lubricate threads and top of washers underside of
bolt head with engine oil. Install head bolts (C) and
torque to specification.
Cylinder Head Bolt Torque:
1) Lubricate threads with engine oil.
2) Torque to 20 +/- 2.5 Nm in sequence as shown on
page 3.6.
3) Back off all bolts 5 turns.
4) Torque to 47.5 +/- 5 Nm in sequence.
5) Tighten an additional 90 degrees (1/4 turn) in
sequence.
*Torque Bolts In Sequence
4. Lubricate push rods (D) and install into lifters.
5. Lubricate rockers (E) with engine oil.
6. Verify pushrods are engaged in lifters.
7. Install rockers. Be sure that tab of fulcrum (F) is
seated in head stand-off. Torque bolts to
specification.
Rocker Arm Bolt:
22 + 2 ft-lbs (30 ± 3 Nm)
ENGINE
To Next Page
Loading...
