9.26
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
3. Install brake pads in caliper body with friction
material facing each other. Install the slide pins and
the slide pin retaining rings. Torque the slide pins to
specification.
NOTE: The slide pins should be torqued when
installed on caliper mount.
Slide Pin Torque:
30-35 ft-lbs (41-48 Nm)
4. Install caliper and torque mounting bolts to
specification.
Caliper Mounting Bolt:
17 ft-lbs (23 Nm)
5. Install brake line and tighten securely with a line
wrench. Torque the brake lines to the proper torque
specification.
6. Follow bleeding procedure outlined in the
“BLEEDING PROCEDURE” in this chapter.
7. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Make sure the brake is not dragging when lever is
released. If the brake drags, re-check assembly and
installation.
BRAKES
To Next Page
Loading...
