BRAKE SYSTEM BREAK-IN
Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.
PVT BREAK-IN (CLUTCHES/BELT)
A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. Break in the clutches and belt by operating at slower
speeds during the break-in period as recommended. Pull only light loads. Avoid
aggressive acceleration and high speed operation during the break-in period.
If a belt fails, always clean any debris from the PVT intake and outlet duct and
from the clutch and engine compartments when replacing the belt.
PRE-RIDE CHECKLIST
Failure to inspect and verify that the ATV is in safe operating condition before
operating increases the risk of an accident. Always inspect the ATV before each
use to make sure it's in safe operating condition.
ITEM REMARKS PAGE
Brake system/lever travel Ensure proper operation
page 31
page 87
Brake fluid
Ensure proper level page 34
Auxiliary brake Ensure proper operation page 34
Front suspension Inspect, lubricate if necessary
-
Rear suspension Inspect, lubricate if necessary
-
Steering Ensure free operation
-
Tires
Inspect condition and pressure page 88
Wheels/fasteners
Inspect, ensure fastener
tightness
-
Frame nuts, bolts, fasteners
Inspect, ensure tightness
-
Fuel and oil
Ensure proper levels page 119
Coolant level
Ensure proper level page 85
Coolant hoses
Inspect for leaks
-
Throttle
Ensure proper operation page 29
Indicator lights/switches Ensure operation page 44
57
OPERATION
To Next Page
Loading...
