3
3.45
28. Remove the fasteners
d
etaining the LH engine
isolator mount to the engine and remove the lower
nut
f
fom the mount. Pry up between the frame and
isolator mount and remove the mount assembly from
the frame.
29. Remove the upper radiator hose
g
from the
thermostat housing. Insert a clean shop towel into
the outlet.
30. Use a heavy-duty tie strap
h
o retain the throttle
body and fuel rail assembly to the upper left-hand
frame support. Doing so allows the TPS, T-MAP, fuel
injectors, IAC hoses and throttle cable to remain
connected to the throttle body.
31. Remove the screws
j
hat retain the throttle body to
the cylinder head. Replace the gaskets upon
installation. Insert a clean shop towel into each
intake track of the engine to prevent debris from
entering.
32. Remove the spade wire (white/red) and battery cable
from starter motor solenoid.
33. Remove engine ground cable from crankcase.
34. Disconnect harness from ECT sensor.
35. Pull the engine toward the front of the vehicle to
disengage the engine coupler from the transmission
input shaft.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
