3.62
CONNECTING ROD BIG END BEARING
SELECTION
1. If using NEW connecting rods, install the bearing
color that matches the bore tolerance letter marked
on the connecting rod cap
q
.
2. If re-installing the original connecting rod, select the
appropriate bearing from the table below based on
connecting rod big end I. D. measurements
(Connecting Rod Big End ID measurement, page
3.59).
Connecting Rod Bearing Selection Chart
Bearing Size Selection Chart – Inches (mm)
Connecting rod journal must be within standard size limits as determined by crankshaft measurements
Con Rod Letter R W B Y
Con Rod Big End
Bore Diameter
1.8892-1.8895″
(47.987mm-
47.993mm)
1.8895-1.8897″
(47.993mm -
47.999mm)
1.8897-1.8899″
(47.999mm -
48.005mm)
1.8899-1.8902″
(48.005mm -
48.011mm)
Target Oil
Clearance (Con
Rod Bearing)
0.0009- 0.0022″
(0.023 mm - 0.057 mm)
Bearing color to
install
Red White Blue Yellow
ENGINE / COOLING SYSTEM
To Next Page
Loading...
